For 5-speed manual VW TDI applications (ALH, BEW, AHU, BRM engines). SFI-approved, rated for 425 ft-lb of torque holding capacity. Includes a 22.5lb single-mass CNC flywheel, Kevlar-lined disc, and Race Engineered (SS) pressure plate. Updated Silent Design friction disc eliminates the idle rattle common to earlier single-mass-flywheel clutch setups.
Recommended use: Rally, endurance racing, clubsport, autocross, street, and daily driving.
Recommended for: Vehicles with a Dual Mass Flywheel (DMF) from factory that are converting to a Single Mass Flywheel (SMF) setup for optimal performance with this kit.
Fitment
| Vehicle | Chassis | Engine | Years |
|---|---|---|---|
| VW Golf TDI | Mk4 (A4) | ALH | 1999.5–2003 |
| VW Golf TDI | Mk4 (A4) | BEW | 2004–2006 |
| VW Jetta TDI | Mk3 (A3) | AHU | 1997–1999 |
| VW Jetta TDI | Mk4 (A4) | ALH | 1999.5–2003 |
| VW Jetta TDI | Mk4 (A4) | BEW | 2004–2005 |
| VW Jetta TDI Wagon | Mk4 (A4) | BEW | 2004–2006 |
| VW Jetta TDI | Mk5 (A5) | BRM | 2005–2006 |
| VW New Beetle TDI | Mk4 (A4) | ALH | 1998–2003 |
| VW New Beetle TDI | Mk4 (A4) | BEW | 2004–2006 |
| VW Passat TDI | B4 | AHU/1Z | 1996–1997 |
Does not fit: 6-speed transmission applications — see the Stage 3 Endurance 6-speed kit for those platforms. Also not for vehicles that already run a single-mass flywheel from factory (no flywheel needed — see the no-flywheel Stage 3 Endurance kit). European-market and other unlisted applications: call 1-877-537-6283 to confirm before ordering.
What's in the Kit
Why Stage 3 Endurance
The pressure plate is shared with the Stage 3 Daily package, but the disc is built specifically for circuit racing use: Kevlar friction material holds a more consistent static-to-dynamic friction ratio at high energy loads than the organic material used in Stage 3 Daily, meaning smoother gear-to-gear transitions under repeated hard use. Torsion springs between the disc and hub dampen driveline shock between engine and gearbox.
FAQ
What's the torque holding capacity of this clutch?
425 ft-lb.
How much does the flywheel weigh?
22.5lb, single-mass, CNC-machined from low-carbon hot-rolled steel.
Is this SFI approved?
Yes — the pressure plate is SFI-approved, same rating used across South Bend's Stage 3 and Stage 4 kits.
Will this clutch rattle at idle?
No. This kit uses South Bend's updated Silent Design friction disc, which resolves the idle rattle associated with older single-mass-flywheel clutch setups.
Does this fit a 6-speed TDI?
No. This SKU (K70316FSSTZ) is 5-speed only. A 6-speed version is available separately.
What's the difference between Stage 3 Daily and Stage 3 Endurance?
Both use the same Race Engineered SFI-approved pressure plate. Stage 3 Daily uses an organic friction disc tuned for OE-like street engagement; Stage 3 Endurance uses a Kevlar disc tuned for repeated high-load use in racing and endurance driving.
