Also known as Unit Injectors, these incorporate the nozzle assembly with a 2000 bar high pressure pump providing each cylinder its own "Unit Injector". This system greatly increases the precision and control over combustion when compared with older fuel injection systems.
With every service we provide a complete tear down and inspection of the PD injector. Following the inspection the injectors are ultrasonically cleaned and rebuilt. Each injector is individually setup to insure the most precise calibration of the two-stage injection. We are able to set the PD injectors back to OEM specs or for custom or race applications we can provide a custom pressure setup according to your specifications
Please note: We can replace and calibrate the injection section of the PD injector ...we cannot rebuild the electronics or pump section. Our service is for servicing and upgrading working PD injectors. Failed PD injectors must be replaced with new PD injectors which we normally have in stock
We now stock a complete range of new nozzles for the entire PD line of engines up to and including Race nozzles for off-road applications. As we always have, we only stock the OEM shims across the complete range of sizes.
Additionally we stock new internal alignment pins and are available as needed during your overhaul.
Please send injectors bubble-wrapped individually to the following address
KermaTDI- Fuel Shop - Invoice #
5737 S Graphite Way
Meridian, ID 83642 USA
Injectors that have run Waste Vegetable Oil / Alternative Fuels... or that have thrown codes or have damage... may not be rebuildable. Purchase of new Bosch PD injectors is the best option. In this case the $200 tear down inspection fee is waived.
